Cisco ASR 9000 Series Installation Guide

Slide the card out of
the chassis.
cPivot the ejector
levers to unseat the
card from the
backplane connector.
bLoosen the captive
screws.
a
Figure 99: Removing a Line Card from the Cisco ASR 9910 Router Chassis
Step 3 Repeat for each RSP or line card.
Removing RP Cards, Fabric Cards, and Line Cards from the Cisco ASR 9922 Router and Cisco ASR
9912 Router
This section describes how to remove the Route Processor (RP) cards, Fabric Card (FC), and Line Cards
(LCs) from the Cisco ASR 9922 Router and Cisco ASR 9912 Router. The table below describes the components
and slot numbering for each router.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
91
Unpacking and Installing the Chassis
Removing RP Cards, Fabric Cards, and Line Cards from the Cisco ASR 9922 Router and Cisco ASR 9912 Router

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model