Cisco ASR 9000 Series Installation Guide

Figure 165: Installing Base Accessories on the Cisco ASR 9912 Router
After the chassis has been installed in the rack and all chassis accessories have been attached, you can install
the fan trays, RP cards, FCs and LCs. See the chapter Installing Cards and Modules in the Chassis in the book
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide for detailed installation
instructions.
Installing Optional Chassis Accessories on the Cisco ASR 9912 Router
The optional chassis accessories for the Cisco ASR 9912 Router include:
• Front door for the line card cage
• Two hinge brackets (left and right side)
• Six screws for attaching the hinge brackets to the chassis
• Rear exhaust air deflector
If you ordered the optional accessories set, follow these steps to install the accessories:
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
155
Unpacking and Installing the Chassis
Installing Optional Chassis Accessories on the Cisco ASR 9912 Router

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model