Cisco ASR 903 Hardware Installation Guide

Table 14: Supported Hot Swapping Combinations
A900-RSP3C-400-SA900-RSP2A-64 and
A900-RSP2A-128
A900-RSP1
Cisco IOS Release 3.16Cisco IOS Release 3.13Cisco IOS Release 3.14
Swapping allowed on all
Ethernet interface
modules
1-port 10 Gigabit Ethernet
XFP Interface Module
(1X10GE)
8-port Gigabit Ethernet
SFP Interface Module
(8X1GE)
8-port Gigabit Ethernet
RJ45 (Copper) Interface
Module (8X1GE)
No support
SFP Combo IM—8-port
Gigabit Ethernet
(8X1GE) +
1-port 10 Gigabit Ethernet
(1X10GE)
No supportCopper Combo
IM—8-port Gigabit
Ethernet (8X1GE)
+ 1-port 10 Gigabit
Ethernet Interface
Module(1X10GE
8-port Gigabit Ethernet
SFP Interface Module
(8X1GE)
8-port Gigabit Ethernet
RJ45 (Copper) Interface
Module (8X1GE)
1-port 10 Gigabit Ethernet
XFP Interface Module
(1X10GE)
No support2-port 10 Gigabit Ethernet
Interface
Module(2X10GE)
Swapping allowed on all
Ethernet interface
modules
No supportNo support8-port 10 Gigabit Ethernet
Interface Module
(8X10GE)
No supportNo support1-port 100 Gigabit
Ethernet Interface Module
(1X100GE)
No supportNo support2-port 40 Gigabit Ethernet
QSFP Interface Module
(2X40GE)
Cisco ASR 903 Aggregation Services Router Hardware Installation Guide
100
Installing the Cisco ASR 903 Router
Hot-Swapping an Interface Module

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1