Cisco ASR 903 Hardware Installation Guide

If a User Account Control warning appears, click “Allow - I trust this program...” to proceed.
Note
Step 5
When the InstallShield Wizard Completed window appears click Finish.
Connecting to the Auxiliary Port
When a modem is connected to the auxiliary port, a remote user can dial in to the router and configure it. Use
a light blue console cable and the DB-9-to-DB-25 connector adapter.
The console cable and DB-9-to-DB-25 connector are not included with the Cisco ASR 903 Router; they
are ordered separately.
Note
To connect a modem to the router, follow these steps:
Step 1
Connect the RJ45 end of the adapter cable to the black AUX port on the router, as shown in the figure below .
Figure 73: Connecting a Modem to the Cisco ASR 903 Router
Cisco ASR 903 Aggregation Services Router Hardware Installation Guide
123
Installing the Cisco ASR 903 Router
Connecting to the Auxiliary Port

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1