To install or remove modules
◦
◦
To remove the cover if you are upgrading the memory or other components
•
#12-24 pan-head screws to secure the router to the equipment rack
•
Cables for connecting to the WAN and LAN ports (depending on the configuration)
For more information on cable specifications, see Troubleshooting.Note
•
Ethernet hub or switch or PC with a network interface card for connecting to the Ethernet ports
•
Console terminal (an ASCII terminal or a PC running terminal emulation software) that is configured
for 9600 baud, 8 data bits, no parity, and 2 stop bits
•
Console cable for connecting to the console port
•
(Optional) Modem for connecting to the auxiliary port for remote administrative access
•
Auxiliary cable for connecting to the auxiliary port (you can supply this cable or order one)
•
Ratcheting torque screwdriver with a Phillips head that exerts up to 30 pound-force per square inch
(in-lb) of pressure
•
Crimping tool as specified by the ground lug manufacturer
•
18 AWG copper wire for the power cord
•
Wire-stripping tools for stripping both 6 AWG and 18 AWG wire
•
Tape measure and level
Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 49Warning
Unpacking and Verifying the Shipped Contents
When you receive your chassis, perform the following steps and use the Shipping Contents Checklist:
Step 1
Inspect the box for any shipping damage. If there is obvious physical damage, contact your Cisco service representative.
Step 2
Unpack the Cisco ASR 903 Router.
Step 3
Perform a visual inspection of the chassis.
Step 4
Use the table below to check the contents of the Cisco ASR 903 Router shipping container. Do not discard the shipping
container. You will need the container if you move or ship the Cisco ASR 903 Router in the future.
Cisco ASR 903 Aggregation Services Router Hardware Installation Guide
76
Preparing for Installation
Unpacking and Verifying the Shipped Contents
To Next Page
Loading...
Need help?
General
