Contents
vi
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-10
Second IOS Process on a Cisco ASR 1002 or 1004 Router 5-4
Route Processor Redundancy 5-5
Stateful Switchover 5-5
SSO-Aware Protocol and Applications 5-6
IPsec Failover 5-6
Bidirectional Forwarding Detection 5-6
CHAPTER
6 Broadband Scalability and Performance 6-1
PPP Sessions and L2TP Tunnel Scaling 6-1
Restrictions for PPP Sessions and L2TP Tunnel Scaling 6-2
IP Sessions Scaling 6-3
Layer 4 Redirect Scaling 6-3
Configuring the Cisco ASR 1000 Series Router for High Scalability 6-3
Configuring Call Admission Control 6-4
Control Plane Policing 6-4
VPDN Group Session Limiting 6-5
PPPoE Session Limiting 6-5
Monitoring PPP Sessions Using the SNMP Management Tools 6-5
Configuring the Access Interface Input and Output Hold Queue 6-5
Configuring the keepalive Command 6-6
Scaling the L2TP Tunnel Configurations 6-6
Using the cisco-avpair="lcp:interface-config" RADIUS Attribute 6-6
Enhancing the Scalability of Per-User Configurations 6-7
Setting the VRF and IP Unnumbered Interface Configurations in User Profiles 6-7
Setting the VRF and IP Unnumbered Interface Configurations in Virtual Interface Templates 6-8
Redefining User Profiles to Use the ip:vrf-id and ip:ip-unnumbered VSAs 6-8
CHAPTER
7 Configuring Call Home 7-1
Information About Call Home 7-1
Benefits of Using Call Home 7-2
How to Obtain Smart Call Home Service 7-2
Prerequisites for Call Home 7-3
How to Configure Call Home 7-3
Configuring the Management Interface VRF 7-4
What To Do Next 7-5
Configuring a Destination Profile 7-5
Configuring a Destination Profile to Send Email Messages 7-5
Configuring a Destination Profile to Send HTTP Messages 7-10