Cisco Catalyst 2960-X Series User Manual

Installing the Power Cord Retainer (Optional)
This section applies only to the Catalyst 2960-X switches.Note
The power cord retainer is optional (part number [PWR-CLP=]). You can order it when you order your switch,
or you can order it later from your Cisco representative.
Procedure
Step 1
Choose the sleeve size of the power cord retainer based on the thickness of the cord. The smaller sleeve can
be snapped off and used for thin cords.
Step 2
Slide the retainer around the AC power cord, and pass it around the loop on the switch.
Figure 22: Inserting the Retainer Through the Lanced Loop
Sleeve for thinner power cords3AC power cord1
Loop4Power cord retainer2
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
OL-28309-02 43
Switch Installation
Installing the Power Cord Retainer (Optional)

Cisco Catalyst 2960-X Series Specifications

General

Operating System	Cisco IOS
Form Factor	Rack-mountable
RAM	512 MB
Model	2960-X Series
Ports	48 x Gigabit Ethernet
Uplink Interfaces	Optional 1G or 10G uplinks
Switching Capacity	Up to 160 Gbps
Stacking	Yes, up to 8 switches
Power over Ethernet	PoE+ (IEEE 802.3at) available on selected models
Dimensions	4.4 x 45 x 28.2 cm (1.73 x 17.7 x 11.1 in)
Weight	5.4 kg
VLANs	4096
Jumbo Frame Support	9198 bytes
Power Supply	100-240VAC, 50-60 Hz
Features	Layer 2 and Layer 3 features, QoS, IPv6 support
Software	LAN Base
Operating Temperature	0 to 45°C (32 to 113°F)