Cisco Catalyst 2960-X Series User Manual

10-95% (non-condensing)Relative humidity
Up to 10,000 ft (3,000 m)Altitude
•
PWR-C2-250WAC: 2.5 lb (1.1 kg)
•
PWR-C2-640WAC: 3.1 lb (1.4 kg)
•
PWR-C2-1025WAC: 3.4 lb (1.6 kg)
Weight
•
PWR-C2-250WAC:1.58 x 10.22 x 3.75 in. (3.5 x 26 x 9.53 cm)
•
PWR-C2-640WAC: 1.58 x 10.22 x 3.75 in. (3.5 x 26 x 9.53 cm)
•
PWR-C2-1025WAC: 1.58 x 11.72 x 3.75 in. (3.5 x 29.8 x 9.53 cm)
Dimensions shown exclude the extraction handle, which measures
1.55 in. (3.9 cm).
Note
Dimensions
Specifications for the Catalyst 2960-X Switches
Table 19: Catalyst 2960X-48FPD-L, 2960X-48LPD-L, 2960X-24PD-L, 2960X-48FPS-L, 2960X-48LPS-L, 2960X-24PSQ-L, and
2960X-24PS-L Switch Specifications
Power Requirements
100 to 240 VAC (autoranging)
• 9 to 4 A, 50 to 60 Hz (Catalyst 2960X-48FPD-L)
•
5 to 2 A, 50 to 60 Hz (Catalyst 2960X-48LPD-L)
• 5 to 2 A, 50 to 60 Hz (Catalyst 2960X-24PD-L)
•
9 to 4 A, 50 to 60 Hz (Catalyst 2960X-48FPS-L)
• 5 to 2 A, 50 to 60 Hz (Catalyst 2960X-48LPS-L)
•
5 to 2 A, 50 to 60 Hz (Catalyst 2960X-24PS-L)
•
2 to 4 A, 50 to 60 Hz (Catalyst 2960X-24PSQ-L)
AC input voltage
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
70 OL-28309-02
Technical Specifications
Specifications for the Catalyst 2960-X Switches

Cisco Catalyst 2960-X Series Specifications

General

Operating System	Cisco IOS
Form Factor	Rack-mountable
RAM	512 MB
Model	2960-X Series
Ports	48 x Gigabit Ethernet
Uplink Interfaces	Optional 1G or 10G uplinks
Switching Capacity	Up to 160 Gbps
Stacking	Yes, up to 8 switches
Power over Ethernet	PoE+ (IEEE 802.3at) available on selected models
Dimensions	4.4 x 45 x 28.2 cm (1.73 x 17.7 x 11.1 in)
Weight	5.4 kg
VLANs	4096
Jumbo Frame Support	9198 bytes
Power Supply	100-240VAC, 50-60 Hz
Features	Layer 2 and Layer 3 features, QoS, IPv6 support
Software	LAN Base
Operating Temperature	0 to 45°C (32 to 113°F)