Cisco Catalyst 3650 Series Configuration Guide

Table 1: Command Mode Summary
About This ModeExit MethodPromptAccess MethodMode
Use this mode to
•
Change
terminal
settings.
•
Perform basic
tests.
•
Display system
information.
Enter logout or
quit.
Switch>
Begin a session
using Telnet, SSH,
or console.
User EXEC
Use this mode to
verify commands
that you have
entered. Use a
password to protect
access to this mode.
Enter disable
to exit.
Switch#
While in user
EXEC mode, enter
the enable
command.
Privileged EXEC
Use this mode to
configure parameters
that apply to the
entire switch.
To exit to
privileged
EXEC mode,
enter exit or
end, or press
Ctrl-Z.
Switch(config)#
While in privileged
EXEC mode, enter
the configure
command.
Global
configuration
Use this mode to
configure VLAN
parameters. When
VTP mode is
transparent, you can
create
extended-range
VLANs (VLAN IDs
greater than 1005)
and save
configurations in the
switch startup
configuration file.
To exit to
global
configuration
mode, enter the
exit command.
To return to
privileged
EXEC mode,
press Ctrl-Z or
enter end.
Switch(config-vlan)#
While in global
configuration
mode, enter the
vlan vlan-id
command.
VLAN
configuration
Use this mode to
configure parameters
for the Ethernet
ports.
Switch(config-if)#
While in global
configuration
mode, enter the
interface command
(with a specific
interface).
Interface
configuration
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
2 OL-32353-01
Using the Command-Line Interface
Command Modes

Cisco Catalyst 3650 Series Specifications

General

RAM	4 GB
Flash Memory	4 GB
Ports	24 or 48 10/100/1000 Ethernet ports
Uplinks	4 x 1G SFP or 4 x 10G SFP+ (depending on model)
Stacking	Up to 9 switches with StackWise-160
Layer Support	Layer 2, Layer 3
Software	Cisco IOS Software
Power Supply	Internal power supply; optional redundant power supply available
Storage Temperature	-40°F to 158°F (-40°C to 70°C)