Switch(config-apgroup)# ap group test-ap-group-16
Switch(config-wlan-apgroup)# wlan test-ap-group-16
Switch(config-wlan-apgroup)# vlan VLAN1300
Related Topics
Information About Access Point Groups, on page 78
Assigning an Access Point to an AP Group
Before You Begin
You must have administrator privileges to perform this operation.
SUMMARY STEPS
1.
ap name ap-name ap-group-name ap-group
DETAILED STEPS
PurposeCommand or Action
Assigns the access point to the access point group. The keywords and arguments
are as follows:
ap name ap-name ap-group-name
ap-group
Step 1
Example:
Switch# ap name 1240-101
ap-groupname apgroup_16
• name—Specifies that the argument following this keyword is the name of
an AP that is associated to the switch.
• ap-name—AP that you want to associate to the AP group.
• ap-group-name—Specifies that the argument following this keyword is the
name of the AP group that is configured on the switch.
• ap-group—Name of the access point group that is configured on the switch.
Related Topics
Information About Access Point Groups, on page 78
Viewing Access Point Group
Before You Begin
You must have administrator privileges to perform this operation.
SUMMARY STEPS
1.
show ap groups [extended ]
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
80 OL-32353-01
Configuring Access Point Groups
Assigning an Access Point to an AP Group
To Next Page
Loading...
Need help?
General
