Because static WEP and 802.1X are both advertised by the same bit in beacon and probe
responses, they cannot be differentiated by clients. Therefore, they cannot both be used
by multiple WLANs with the same SSID.
Note
•
WPA/WPA2
Although WPA and WPA2 cannot be used by multiple WLANs with the same SSID,
you can configure two WLANs with the same SSID with WPA/TKIP with PSK and
Wi-Fi Protected Access (WPA )/Temporal Key Integrity Protocol (TKIP) with 802.1X,
or with WPA/TKIP with 802.1X or WPA/AES with 802.1X.
Note
Related Topics
Configuring Static WEP + 802.1X Layer 2 Security Parameters (CLI), on page 61
Configuring Layer 2 Parameters (GUI), on page 66
Configuring Static WEP Layer 2 Security Parameters (CLI), on page 62
Configuring Layer 2 Parameters (GUI), on page 66
Configuring WPA + WPA2 Layer 2 Security Parameters (CLI), on page 63
Configuring Layer 2 Parameters (GUI), on page 66
Configuring 802.1X Layer 2 Security Parameters (CLI), on page 64
Configuring Layer 2 Parameters (GUI), on page 66
Configuring Advanced WLAN Properties (CLI), on page 36
Information About AAA Override, on page 60
Information About AAA Override
The AAA Override option of a WLAN enables you to configure the WLAN for identity networking. It enables
you to apply VLAN tagging, Quality of Service (QoS), and Access Control Lists (ACLs) to individual clients
based on the returned RADIUS attributes from the AAA server.
Related Topics
Configuring Advanced WLAN Properties (CLI), on page 36
Prerequisites for Layer 2 Security, on page 59
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
60 OL-32353-01
Configuring WLAN Security
Information About AAA Override
To Next Page
Loading...
Need help?
General
