The SNMP System Summary page appears.
Step 6
On the SNMP System Summary page, enter the following SNMP system parameters for the switch, and click Next:
•
Customer-definable switch location in the Location text box.
•
Customer-definable contact details such as phone number with names in the Contact text box.
•
Choose enabled to send SNMP notifications for various SNMP traps or disabled not to send SNMP notifications
for various SNMP traps from the SNMP Global Trap drop-down list.
•
Choose enabled to send system log messages or disabled not to send system log messages from the SNMP Logging
drop-down list.
The SNMP trap server, must be reachable through the distribution ports (and not through the gigabitethernet0/0
service or management interface).
Note
The Management Port page appears.
Step 7
In the Management Port page, enter the following parameters for the management port interface (gigabitethernet 0/0)
and click Next.
•
Interface IP address that you assigned for the service port in the IP Address text box.
•
Network mask address of the management port interface in the Netmask text box.
•
The IPv4 Dynamic Host Configuration Protocol (DHCP) address for the selected port in the IPv4 DHCP Server
text box.
The Wireless Management page appears.
Step 8
In the Wireless Management page, enter the following wireless interface management details, and click Next.
• Choose the interface—VLAN, or Ten Gigabit Ethernet from the Select Interface drop-down list.
•
VLAN tag identifier, or 0 for no VLAN tag in the VLAN id text box.
•
IP address of wireless management interface where access points are connected in the IP Address text box.
•
Network mask address of the wireless management interface in the Netmask text box.
•
DHCP IPv4 IP address in the IPv4 DHCP Server text box.
When selecting VLAN as interface, you can specify the ports as –Trunk or Access ports from the selected list displayed
in the Switch Port Configuration text box.
The RF Mobility and Country Code page appears.
Step 9
In the RF Mobility and Country Code page, enter the RF mobility domain name in the RF Mobility text box, choose
current country code from the Country Code drop-down list, and click Next. From the GUI, you can select only one
country code.
Before configuring RF grouping parameters and mobility configuration, ensure that you refer to the relevant
conceptual content and then proceed with the configuration.
Note
The Mobility Configuration page with mobility global configuration settings appears.
Step 10
In the Mobility Configuration page, view and enter the following mobility global configuration settings, and click Next.
•
Choose Mobility Controller or Mobility Agent from the Mobility Role drop-down list:
WLAN Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches)
OL-32353-01 17
Using the Web Graphical User Interface
Configuring the Switch Web GUI
To Next Page
Loading...
Need help?
General
