Cisco Catalyst 3750-X Message Guide

2-95
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
QOSMGR Messages
Error Message QOSMGR-4-ACTION_NOT_SUPPORTED: Action is not supported in policymap
[chars].
Explanation An action other than the set, trust, and police policy-map class configuration
commands was configured in a policy map. This is a hardware limitation. [chars] is the policy-map
name.
Recommended Action Configure only the supported actions of set, trust, and police when in
policy-map class configuration mode.
Error Message QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not supported in
classmap [chars].
Explanation An unsupported match class-map configuration command was configured in a policy
map and attached to an egress interface, or more than one match class-map command was
configured. This is a hardware limitation. [chars] is the class-map name.
Recommended Action Reconfigure the class map or the policy map. Use only the match ip dscp
dscp-list class-map configuration command in a policy map that is attached to an egress interface.
Only one match per class map is supported.
Error Message QOSMGR-4-COMMAND_FAILURE: Execution of [chars] command failed.
Explanation The command to configure a QoS setting failed. This is possibly due to lack of hardware
resources. [chars] is the description of the command.
Recommended Action Look for any other messages that indicate resource failure. If other messages
indicate that the hardware resources are exceeded, retry the command with a smaller configuration.
If the message appears again, copy the message exactly as it appears on the console or in the system
log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit
to look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error
Message Traceback Reports” section on page 1-7.
Recommended Action QOSMGR-4-HARDWARE_NOT_SUPPORTED: Hardware limitation has
reached for policymap [chars].
Explanation The policy-map configuration has exceeded the limitation of the hardware. You
configured more QoS ACL entries than the number specified in the SDM template. [chars] is the
policy-map name.
Recommended Action Reconfigure the class map or the policy map, and reduce the number of QoS
ACLs.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing