Name: Cisco Catalyst 9124AX Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

The C9124AX Series AP uses an internal omni BLE antenna.

Note

• Available in three model SKUs: Omni (-I) antenna (C9124AXI-x), Directional (-D) antenna

(C9124AXD-x), and External (-E) antenna (C9124AXE-x).

• Four dual-band 2.4-GHz and 5-GHz integrated antennas on the C9124AX AP models (C9124AXI-x and

C9124AXD-x).

• Four dual-band 2.4-GHz and 5-GHz, and two 5-GHz antenna ports on the C9124AXE AP model

(C9124AXE-x).

The x in the model numbers represents the regulatory domain. For information about supported regulatory

domains, see AP Model Numbers and Regulatory Domains, on page 3.

Note

• MU-MIMO technology for uplink and downlink.

• OFDMA-based scheduling for both uplink and downlink.

• Multigigabit Ethernet (mGig)

• The following hardware external interfaces:

• 1x100/1000/2500 Multigigabit Ethernet (PD or PoE-IN)

• 1xSFP port (Uplink)

• 1x1G Ethernet port (PSE or PoE-Out)

• RS-232 Console Interface through RJ-45

• Recovery push button (enables partial or full system configuration recovery)

• One multicolor LED status indicator. For information about the colors of the LED status indicator,

see Checking the Access Point LEDs, on page 82.

• Integrated Bluetooth Low Energy (BLE) radio enables IoT use cases such as location tracking and

wayfinding.

• Cisco RF ASIC, a fully integrated Software Defined Radio (SDR), can perform advanced radio frequency

(RF) spectrum analysis, and deliver features such as next-generation CleanAir, Wireless Intrusion

Prevention System (WIPS), Dynamic Frequency Selection (DFS) detection.

• Intelligent Capture probes the network and provides Cisco Digital Network Architecture (DNA) Center

with in-depth analysis.

• Spatial Reuse (also known as Basic Service Set [BSS] coloring) allows the AP and their clients to

differentiate between BSS, thus permitting simultaneous transmissions.

• A new power savings mode called Target Wake Time (TWT) allows clients to stay asleep and wake up

only at prescheduled (target) times to exchange data with the AP. This mode provides significant energy

savings for battery-operated devices.

Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide

About the Cisco Catalyst 9124AX Series Outdoor Access Point

Cisco Catalyst 9124AX Series Outdoor Access Point Features

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst 9124AX Series and is the answer not in the manual?

Cisco Catalyst 9124AX Series Specifications

General