This equipment must be externally grounded using a customer-supplied ground wire before power is
applied. Contact the appropriate electrical inspection authority or an electrician if you are uncertain
that suitable grounding is available. Statement 366
Danger
Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement
1001
Danger
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Danger
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
1022
Danger
To reduce the risk of fire, use only No. 24 AWG or larger telecommunication line cord. Statement 1023
Danger
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Danger
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
requirements in IEC 60950 based safety standards. Statement 1033
Danger
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Danger
When installing or replacing the unit, the ground connection must always be made first and disconnected
last. Statement 1046.
Danger
Class 1 Laser Product. Statement 1008
Danger
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
90
Safety Guidelines and Warnings
To Next Page
Loading...
Need help?
General
