Cisco Catalyst 9500

Registering a Device with the New Token
To register a device with the new token, perform this procedure:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Enter your password, if prompted.
Device> enable
Registers the device with the back-end server
using the token generated from CSSM.
license smart register idtoken token_ID
Example:
Step 2
Device# license smart register idtoken
$Tl4UytrNXBzbEs1ck8veUtWaG5abnZJOFdDa1FwbVRa%0AblRMbz0%3D%0A
Saves the license information on the device.write memory
Example:
Step 3
Device# write memory
Verifying the License Status After Registration
To verify the status of a license after registration, use the show license all command.
Device> enable
Device# show license all
Smart Licensing Status
======================
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
109
Configuring Smart Licensing
Registering a Device with the New Token