Cisco Catalyst 9500 User Manual

Monitoring and Troubleshooting the Feature
Perform this task to monitor and troubleshoot the Configuration Replace and Configuration Rollback feature.
Procedure
Step 1 enable
Use this command to enable privileged EXEC mode. Enter your password if prompted.
Example:
Device> enable
Device#
Step 2 show archive
Use this command to display information about the files saved in the Cisco IOS configuration archive.
Example:
Device# show archive
There are currently 1 archive configurations saved.
The next archive file will be named flash:myconfiguration-2
Archive # Name
0
1 flash:myconfiguration-1 <- Most Recent
2
3
4
5
6
7
8
9
10
11
12
13
14
The following is sample output from the show archive command after several archive files of the running
configuration have been saved. In this example, the maximum number of archive files to be saved is set to
three.
Example:
Device# show archive
There are currently 3 archive configurations saved.
The next archive file will be named flash:myconfiguration-8
Archive # Name
0
1 :Deleted
2 :Deleted
3 :Deleted
4 :Deleted
5 flash:myconfiguration-5
6 flash:myconfiguration-6
7 flash:myconfiguration-7 <- Most Recent
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
261
Configuration Replace and Configuration Rollback
Monitoring and Troubleshooting the Feature

Cisco Catalyst 9500 Specifications

General

Software	Cisco IOS XE
Energy Efficiency	Energy Efficient Ethernet (EEE)
Warranty	Limited Lifetime Hardware Warranty
Series	Catalyst 9500
Ports	Up to 48 ports (varies by model)
Power Supply	Redundant power supplies
Operating Temperature	0°C to 40°C
Weight	Up to 35 lbs (varies by model)
Memory	16 GB DRAM, 16 GB Flash
Modularity	Modular uplinks and power supplies
Security	Cisco TrustSec, MACsec
Redundancy	Power supply redundancy
Management	CLI, SNMP, NETCONF
Latency	Sub-microsecond