Cisco Catalyst 9500

PurposeCommand or Action
]/filename ] | tftp:[[[//location ]/directory
]/filename ]}
Example:
Device(config)# boot network
ftp://user1:guessme@example.com/dir10/file1
Enables the switch to download configuration
files at system startup.
service config
Example:
Step 5
Device(config)# service config
Exits global configuration mode.end
Example:
Step 6
Device(config)# end
Saves the configuration.copy system:running-config
nvram:startup-config
Step 7
Example:
Device# copy system:running-config
nvram:startup-config
Copying Configuration Files from Flash Memory to the Startup or Running
Configuration
To copy a configuration file from flash memory directly to your startup configuration in NVRAM or your
running configuration, enter one of the commands in Step 2:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
• Enter your password if prompted.
Device> enable
Do one of the following:
Step 2
• Loads a configuration file directly into
NVRAM or
• copy filesystem:
[partition-number:][filename ]
nvram:startup-config
• Copies a configuration file to your running
configuration
• copy filesystem:
[partition-number:][filename ]
system:running-config
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
231
Managing Configuration Files
Copying Configuration Files from Flash Memory to the Startup or Running Configuration