Cisco Catalyst 9500

PurposeCommand or Action
• The revert trigger keywords set the
following triggers for reverting to the
original configuration:
• error —Reverts to the original
configuration upon error.
• timer minutes —Reverts to the
original configuration if specified
time elapses.
• The ignore case keyword allows the
configuration to ignore the case of the
confirmation command.
(Optional) To cancel the timed rollback and
trigger the rollback immediately, or to reset
configure revert { now | timer {minutes | idle
minutes} }
Step 3
parameters for the timed rollback, use the
Example:
conf igure re vertcommand in privileged EXEC
mode.
Device# configure revert now
• now —Triggers the rollback immediately.
• timer —Resets the configuration revert
timer.
• Use the minutes argument with the
timer keyword to specify a new
revert time in minutes.
• Use the idle keyword along with a
time in minutes to set the maximum
allowable time period of no activity
before reverting to the saved
configuration.
(Optional) Confirms replacement of the current
running configuration file with a saved Cisco
IOS configuration file.
configure confirm
Example:
Device# configure confirm
Step 4
Use this command only if the time
seconds keyword and argument
of the configure replace
command are specified.
Note
Exits to user EXEC mode.exit
Example:
Step 5
Device# exit
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
260
Configuration Replace and Configuration Rollback
Performing a Configuration Replace or Configuration Rollback Operation