Cisco Catalyst 9500

DescriptionAttribute
Do not disable. Run this test if the task of writing
values to the registers fails. This can be run as a
health-monitoring test and also as an on-demand test.
Recommendation
On.Default
Cisco IOS XE Everest 16.6.1.Intitial release
–Corrective action
Supervisors and linecards.Hardware support
DiagPoETest
This test checks the PoE controller functionality. Do not perform this test during normal switch operation.
DescriptionAttribute
Disruptive.Disruptive or Nondisruptive
Run this test if you experience PoE controller issues
with a port. This can be run only as an on-demand
test.
Recommendation
Off.Default
Cisco IOS XE Everest 16.6.1.Intitial release
–Corrective action
Linecards.Hardware support
DiagStackCableTest
This test verifies the stack-ring loopback functionality in the stacking environment. It cannot be run as a
health-monitoring test.
DescriptionAttribute
Disruptive.Disruptive or Nondisruptive
Run this test to verify the stack-ring loopback
functionality in the stacking environment.
Recommendation
Off.Default
Cisco IOS XE Everest 16.6.1.Intitial release
If the test fails, check the stack cables and connectors.Corrective action
Supervisors.Hardware support
DiagMemoryTest
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
194
Configuring Online Diagnostics
Generic Online Diagnostics (GOLD) Tests