• Effect of damage on the installation
Package Contents
Each Cisco Catalyst 9800-L Wireless Controller package contains the following items:
• One Cisco Catalyst 9800-L Wireless Controller
• One Power supply and power cord (power cord option configurable)
• Optional licenses will be pre-installed on controller at factory, if selected
• Cisco Catalyst 9800-L Wireless Controller software pre-loaded on the controller (software option
configurable)
• Four adhesive rubber feet pieces
Requirements Tools and Information
You will need the following tools and information before you can install the controller:
• Wireless controller hardware
• Controller with factory-supplied power cord and mounting hardware
• Network, operating system service network, access point cables, and adapter are required
• Command-line interface (CLI) console
• Serial terminal emulator on CLI console (PC or laptop)
• Use either RJ-45 console cable or Micro USB Type-B cable to connect CLI console and controller
Choosing a Physical Location
You can install the controller almost anywhere, but it is more secure and reliable if you install it in a secure
equipment room or wiring closet. For maximum reliability, mount the controller while following these
guidelines:
• Make sure you can reach the controller and all cables attached to it.
• Make sure that water or excessive moisture cannot get into the controller.
• To prevent airflow restriction, allow clearance around the ventilation openings to be at least 50 mm (5
cm).
• Verify that the ambient temperature remains between 32° F to 104° F (0° C to 40° C).
Cisco Catalyst 9800-L Wireless Controller Hardware Installation Guide
10
Preparing Your Site for Installation
Package Contents
To Next Page
Loading...
Need help?
General
