Cisco Catalyst Express 500-24LC - When You Are Done

5-11
User Guide for the Catalyst Express 500 Switches
OL-8122-01
Chapter 5 Troubleshooting
When You Are Done
When You Are Done
Use the diagnostic tools and troubleshooting features to solve network problems
as they come up.
For additional resources that can help you troubleshoot problems, see Chapter ,
“Cisco Support Resources.”
Boot with the factory
default IOS image
Use this option to use the factory-default software image. Settings for
features supported on the default software image are retained, including
the IP address, usernames, and passwords.
Use this option if a software upgrade fails. Display the device manager,
and try to upgrade the switch software again.
Erase system configuration
and boot with the factory
default IOS image
Use this option to delete all of the configuration settings on the switch
and to change to the factory-default software image. All files on the
switch Flash image are deleted and the switch returns to using the
factory default image.
If you select this option, you must set up the switch again, as described
in the Getting Started Guide for the Catalyst Express 500 Switches.