Chapter 2 Setup and Installation
Install the Switch
2-8
User Guide for the Catalyst Express 500 Switches
OL-8122-01
Warning
This equipment must be grounded. Never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor.
Contact the appropriate electrical inspection authority or an electrician if you
are uncertain that suitable grounding is available.
Statement 1024
Warning
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment.
Statement 1030
Warning
Ultimate disposal of this product should be handled according to all national
laws and regulations.
Statement 1040
Warning
For connections outside the building where the equipment is installed, the
following ports must be connected through an approved network termination
unit with integral circuit protection: 10/100/1000 Ethernet.
Statement 1044
Warning
Voltages that present a shock hazard may exist on Power over Ethernet (PoE)
circuits if interconnections are made using uninsulated exposed metal
contacts, conductors, or terminals. Avoid using such interconnection methods,
unless the exposed metal parts are located within a restricted access location
and users and service people who are authorized within the restricted access
location are made aware of the hazard. A restricted access area can be
accessed only through the use of a special tool, lock and key or other means of
security.
Statement 1072
Warning
Installation of the equipment must comply with local and national electrical
codes.
Statement 1074
To Next Page
Loading...
