Figure 8: Switch Mounted on a Cable Duct with Anchor Rail
How to Mount the Switch in a Front-Locking Cable Duct
This topic describes the installation procedure for mounting the switch on a front-locking duct. This procedure
assumes that you have an existing duct with mounting bracket assembly installed.
Before you begin
This mounting option is currently not supported. Support for front-locking duct will be available in a later
release.
Note
Ensure you have the following accessories available before starting the installation.
Cisco Catalyst Micro Series Switch Hardware Installation Guide
31
Switch Installation
How to Mount the Switch in a Front-Locking Cable Duct
To Next Page
Loading...
