Introduction
Set Up Your Device for the First Time
When you start the system for the rst time,
you are invited to run a wizard. Just tap Get
started.
Enter your username and tap Continue.
Finally, it is time to make yourself feel at
home. You are now invited to put your
favorite apps as shortcuts on your screen.
You receive a prompt to log into Cisco
WebEx. Enter your WebEx username and
tap Next.
You then receive a prompt to enter your
username and password for your voicemail.
You are now done!
You receive a prompt to sign in to WebEx
Messenger or CUCM IM and Presence.
Tap the one that applies to you.
To synchronize your contacts and your
calendar, provide your Email address and
the corresponding password.
About Setup
Provided that self-provisioning is
allowed in your organization, your
system automatically prompts you to
enter the usernames and passwords
for the appropriate accounts.
Note This wizard does not appear
for units that run in the Call
application.
After you run this wizard, in most
cases, your receive a prompt to
provide a PIN or password to
restrict access to your unit. See the
following page for details.
If for some reason you want to run
this wizard at a later stage, use
Settings > Setup Assistant.
To Next Page
Loading...
Need help?
General
