D1510406 English
User Guide Cisco DX70, Cisco DX80
Produced: November 2014, All Contents © 2014
Cisco Systems, Inc. All Rights Reserved.
Security
Set a PIN or Password to Restrict Access
About PIN and Password
The system normally prompts you to
enter a PIN or password to prevent
unrestricted access to your system.
If you later want to change your
password or PIN, the procedure is
the same, but you have to access
the Settings menu rst.
To access the Settings menu, start
from Home screen and tap in the
lower right corner as shown in ”Set
or Change Screen-Lock Timeout”
on page 11.
The example shown here assumes
that you choose a PIN rather than
a password. The procedure is the
same in both cases, except that
a password typically consists of a
mixture of alphanumeric characters.
Tap Screen lock.
Using PIN as example, the system prompts you to enter a
four-digit PIN code.
To prevent lockout, you now receive a prompt to conrm
your PIN code. Enter the PIN code and tap OK.
Tap PIN or Password. Selection of None, if possible,
creates a vulnerable system and is not recommended.
Tap Continue when you are done.
Tap Home when you are done.
To Next Page
Loading...
Need help?
General
