Cisco EX90 - Calling Entries from Any Directory; Accessing the Contacts Directory

29
Cisco TelePresence System EX90/EX60 Administrator guide
D14726.03 Cisco TelePresence System EX90-EX60 Administrator Guide TC4.0, December 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Advanced conguration
Conference [1..1] TelephonyPrex
Enter the prex to be used for telephony calls.
Requires user role: ADMIN
Value space: <S: 0, 80>
Format: String with a maximum of 80 characters.
Ex a m ple: Conference 1 TelephonyPrex: "520"
Conference [1..1] MaxTransmitCallRate
Specify the maximum transmit call rate to be used when placing or receiving calls.
Requires user role: ADMIN
Value space: <64..6000>
Range: Select a value from 64 to 6000 kbps.
Ex a m ple: Conference 1 MaxTransmitCallRate: 6000
Conference [1..1] MaxReceiveCallRate
Specify the maximum receive call rate to be used when placing or receiving calls.
Requires user role: ADMIN
Value space: <64..6000>
Range: Select a value from 64 to 6000 kbps.
Ex a m ple: Conference 1 MaxReceiveCallRate: 6000
Conference [1] IncomingMultisiteCall Mode
Set the incoming MultiSite call mode. The MultiSite feature allows participants from more than two
locations to join a meeting — by video and/or telephone.
Requires user role: ADMIN
Value space: <Allow/Deny>
Allow: Accept incoming calls to an already active call/conference. The incoming call will be added
to the MCU conference.
Deny: The system will not accept incoming calls when you are in a call. The calling side will
receive a busy signal.
Ex a m ple: Conference 1 IncomingMultisiteCall Mode: Allow
Conference [1..1] AutoAnswer Mode
Set the AutoAnswer mode.
Requires user role: ADMIN
Value space: <On/O>
On: Enable AutoAnswer to let the system automatically answer all incoming calls.
O: The incoming calls must be answered manually by pressing the green Accept key on the
touch screen controller.
Ex a m ple: Conference 1 AutoAnswer Mode: Off
Conference [1..1] AutoAnswer Mute
Determine if the microphone shall be muted when an incoming call is automatically answered. Note:
Requires the AutoAnswer Mode to be enabled.
Requires user role: ADMIN
Value space: <On/O>
On: The incoming call will be muted when automatically answered.
O: The incoming call will not be muted.
Ex a m ple: Conference 1 AutoAnswer Mute: Off
Conference [1..1] AutoAnswer Delay
Dene how long (in seconds) an incoming call has to wait before it is answered automatically by the
system. Note: Requires the AutoAnswer Mode to be enabled.
Requires user role: ADMIN
Value space: <0..50>
Range: Select a value from 0 to 50 seconds.
Ex a m ple: Conference 1 AutoAnswer Delay: 0
Conference [1..1] MicUnmuteOnDisconnect
Determine if the microphones should be unmuted automatically when all calls are disconnected. In a
meeting room or other shared resource this could be done to prepare the system for the next user.
Requires user role: ADMIN
Value space: <On/O>
On: Un-mute the microphones after the call is disconnected.
O: If muted, let the microphones remain muted after the call is disconnected.
Ex a m ple: Conference 1 MicUnmuteOnDisconnect: On
The Conference settings The Conference settings, cont...