37
Cisco TelePresence System EX90/EX60 Administrator guide
D14726.03 Cisco TelePresence System EX90-EX60 Administrator Guide TC4.0, December 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Advanced conguration
Network [1..1] IEEE8021X Eap Md5
Set the Md5 (Message-Digest Algorithm 5) mode. This is a Challenge Handshake Authentication
Protocol that relies on a shared secret. Md5 is a Weak security.
Requires user role: ADMIN
Value space: <On/O>
On: The EAP-MD5 protocol is enabled (default).
O: The EAP-MD5 protocol is disabled.
Ex a m ple: Network 1 IEEE8021X Eap Md5: On
Network [1..1] IEEE8021X Eap TTLS
Set the TTLS (Tunneled Transport Layer Security) mode. Authenticates LAN clients without the
need for client certicates. Developed by Funk Software and Certicom. Usually supported by Agere
Systems, Proxim and Avaya.
Requires user role: ADMIN
Value space: <On/O>
On: The EAP-TTLS protocol is enabled (default).
O: The EAP-TTLS protocol is disabled.
Ex a m ple: Network 1 IEEE8021X Eap TTLS: On
Network [1..1] IEEE8021X Eap Peap
Set the Peap (Protected Extensible Authentication Protocol) mode. Authenticates LAN clients without
the need for client certicates. Developed by Microsoft, Cisco and RSA Security.
Requires user role: ADMIN
Value space: <On/O>
On: The EAP-PEAP protocol is enabled (default).
O: The EAP-PEAP protocol is disabled.
Ex a m ple: Network 1 IEEE8021X Eap Peap: On
Network [1..1] TracControl Mode
Set the network trac control mode to decide how to control the video packets transmission speed.
Requires user role: ADMIN
Value space: <On/O>
On: Transmit video packets at maximum 20 Mbps. Can be used to smooth out bursts in the
outgoing network trac.
O: Transmit video packets at link speed.
Ex a m ple: Network 1 TrafcControl: On
Network [1..1] RemoteAccess Allow
Filter IP addresses for access to ssh/telnet/HTTP/HTTPS.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: String with a maximum of 255 characters, comma separated IP addresses or IP range.
Ex a m ple: Network 1 RemoteAccess Allow: "192.168.1.231, 192.168.1.182"
The Network settings, cont... The Network settings, cont...