Cisco Explorer Series - Setting up the DNCS for Cablecard Module Staging

Setting Up the DNCS for CableCARD Module Staging
734375 Rev H 79
Setting Up the DNCS for CableCARD Module
Staging
For the procedures to set up your DNCS for staging CableCARD modules, refer to
one of the following documents:
 Best Practices for Using Single-Stream PowerKEY CableCARD Modules (part number
4015091)
 Setting Up Dual Sources and Hiding Services from One-Way CableCARD Hosts (part
number 4011367)
To improve the staging of CableCARD modules, our engineers have identified the
following three best practices:
 Configure a download for a default group of CableCARD modules.
 Avoid sending download-related uncfg messages to CableCARD modules.
 Do not provision CableCARD modules as part of the staging process.