Cisco Explorer Series

To Next Page

To Previous Page

Staging CableCARD Modules

734375 Rev H 81

Staging with No Billing Action Process

The following flowchart illustrates the staging process for CableCARD (CC)

modules when you can set up your billing system with no billing action.

Main Page

Default Chapter5
- Table of Contents5
About this Guide9
The Staging Process11
- 1 Chapter 1 The Staging Process12
Staging Preparations19
- 2 Chapter 2 Staging Preparations20
Optimize Your System Performance for Downloads and Staging31
- Overview32
- Recommendations to Improve Your Staging and Software Download Performance33
- Recommendations to Improve Your Data Carousel Rate44
Staging Area Considerations55
- 4 Chapter 4 Staging Area Considerations56
Obtain and Load EMM Data63
- 5 Chapter 5 Obtain and Load EMM Data64
How to Stage Dhcts77
- 6 Chapter 6 How to Stage Dhcts78
How to Stage Cablecard Modules87
- 7 Chapter 7 How to Stage Cablecard Modules88
Returning Dhcts and Cablecard Modules to Service97
- Check for Stranded IPPV Events and Clear NVM98
- Returning Cablecard Modules to Service102
Troubleshooting103
- 9 Chapter 9 Troubleshooting104
Customer Information119
Appendix A Download LED Indicators121
- This Appendix Contains Explanations of What the Front Panel Light-122
- In this Appendix122
- Overview122
- LED Indicators Displayed During an OSM Download123
- LED Indicators Displayed During a CVT Download126
- Dhcts with Three LED Indicators129
- Dhcts with Single LED Indicators132
- POWER LED Indicators Displayed on Dhcts135
Appendix B Button Sequence for DHCT Functions139
- Button Sequences140
- E940 Forced Download Button141
Appendix C Setting up Multiple Bootloader Carousels143
- This Appendix Examines Why It Might be Beneficial for a Site to Use144
- Overview144
- Determine Available Bandwidth for Multiple Bootloaders146
- Setting up Multiple Bootloader Carousels150
- Adding a Bootloader Source to the DNCS152
- Setting up Dhcts to Download Images from a Specific Bootloader Carousel154
Appendix D Adding an HDD Test Server to the BFS157
- This Appendix Includes the Tasks Required to Set up the BFS to Support158
- Overview158
- Adding an HDD Test Server to the BFS160
- Registering the HDD Test Server with the BFS164
- Placing the HDD Performance Specification File on the HDD Test Server166
Appendix E Format the Hard Drive Without Clearing NVM167
- Formatting the Hard Drive168
Appendix F Staging Out-Of-Band Bridges169
- Overview170
- Set up Staging Bridges172
Appendix G Staging Toolkit175
- Overview176
- Remote Controls177
- Activating the Staging Toolkit for Dhcts with Alphanumeric Leds178
- Activating the Staging Toolkit for Dhcts with Single or Triple Leds179
Index181

Cisco Explorer Series - Page 91

Table of Contents

Related product manuals