EasyManuals Logo

Cisco Firepower 1100 Getting Started Guide

Cisco Firepower 1100
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #143 background imageLoading...
Page #143 background image
Step 2 Choose DHCP > DHCP Server.
Step 3 On the Server page, click Add, and configure the following options:
Interface—Choose the interface from the drop-down list.
Address Pool—Set the range of IP addresses from lowest to highest that are used by the DHCP server.
The range of IP addresses must be on the same subnet as the selected interface and cannot include the
IP address of the interface itself.
Enable DHCP Server—Enable the DHCP server on the selected interface.
Step 4 Click OK.
Step 5 Click Save.
Configure NAT
A typical NAT rule converts internal addresses to a port on the outside interface IP address. This type of NAT
rule is called interface Port Address Translation (PAT).
Procedure
Step 1 Choose Devices > NAT, and click New Policy > Threat Defense NAT.
Step 2 Name the policy, select the device(s) that you want to use the policy, and click Save.
Cisco Firepower 1100 Getting Started Guide
141
Threat Defense Deployment with CDO
Configure NAT

Table of Contents

Other manuals for Cisco Firepower 1100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Firepower 1100 and is the answer not in the manual?

Cisco Firepower 1100 Specifications

General IconGeneral
BrandCisco
ModelFirepower 1100
CategoryFirewall
LanguageEnglish

Related product manuals