Cisco Firepower 1100 Getting Started Guide

• Source Zones—Select the inside zone from Available Zones, and click Add to Source.
• Destination Zones—Select the outside zone from Available Zones, and click Add to Destination.
Leave the other settings as is.
Step 3 Click Add.
The rule is added to the Rules table.
Step 4 Click Save.
Deploy the Configuration
Deploy the configuration changes to the threat defense; none of your changes are active on the device until
you deploy them.
Procedure
Step 1 Click Deploy in the upper right.
Figure 9: Deploy
Step 2 Either click Deploy All to deploy to all devices or click Advanced Deploy to deploy to selected devices.
Cisco Firepower 1100 Getting Started Guide
36
Threat Defense Deployment with the Management Center
Deploy the Configuration

Cisco Firepower 1100 Specifications

General

Brand	Cisco
Model	Firepower 1100
Category	Firewall
Language	English