NOTE
Each individual Fluidmesh radio transceiver unit has a factory-
set 5.a.b.c Mesh identification number. Each unit is shipped
from the factory with the same IP address, but with a unique
Mesh identification number.
IMPORTANT
IP addresses must not be duplicated within a network. If
addresses are duplicated, IP address conflicts will occur.
IMPORTANT
The Cisco FM Ponte kit is designed as a Bridge device only. It
cannot be configured as a Mesh Point or Mesh End device.
Getting Started
© 2021 Cisco and/or its affiliates. All rights reserved. Page 14 of 132
To Next Page
Loading...
