• SIGNAL STRENGTH (red): Signal strength very poor.
• SIGNAL STRENGTH (yellow): Signal strength inadequate.
• SIGNAL STRENGTH (green): Signal strength acceptable.
• SIGNAL STRENGTH (green): Signal strength excellent.
TIP
During normal operation, the readings from the four SIGNAL
STRENGTH LEDs can be used to do radio antenna alignment
(see “Antenna-alignment tools and physical statistics” (page
49) for more information).
Boot sequence
During the unit's boot sequence, the four SIGNAL STRENGTH LEDs light
up in sequence. During the boot sequence, the LEDs indicate the
following conditions:
1. Red: Core system boot in progress.
2. Yellow: Wireless system boot in progress.
3. First green: Routing engine boot in progress.
4. Second green: Unit configuration boot in progress.
If the boot sequence above stops at any LED, an error has been detected
during that stage of the boot sequence.
5.1.4. Supplying power to the Cisco FM Ponte kit
CAUTION
When connecting the Cisco FM Ponte kit to a power supply, be
sure to follow the instructions in this section at all times.
Failure to follow these instructions may result in irreparable
damage to the unit and/or other connected hardware, and will
also invalidate the product warranty.
IMPORTANT
For technical data on which power sources are compatible with
the Cisco FM Ponte kit, refer to “Electrical power requirements”
(page 115).
The Cisco FM Ponte kit can be provided with power using the following
methods:
• The included 24 Vdc passive PoE injector (90 Vac to 260 Vac,
50/60 Hz input).
Hardware installation
© 2021 Cisco and/or its affiliates. All rights reserved. Page 21 of 132
To Next Page
Loading...
