7. Device configuration using the configurator
interface
All Fluidmesh radio transceiver devices are shipped with IP address
192.168.0.10, and Netmask 255.255.255.0.
The Cisco FM Ponte kit can be configured by using:
• The on-board Configurator interface.
The Configurator is a localized configuration software platform that
resides on the Fluidmesh device.
• Local configuration is done by connecting a computer to the device
through a direct hardware connection, or through the internet.
• Using the Configurator, devices can be configured on an Offline
basis only. A configuration (*.CONF) file can be manually applied to
set the device parameters, or each device parameter can be
manually set by the device user.
• Offline configuration settings for more than one Fluidmesh device
type can be integrated into a single configuration file. When the
configuration file is uploaded to each device, the device
automatically loads the correct configuration settings for its device
type.
To configure the unit using the Configurator, refer to the following sub-
sections.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 35 of 132
To Next Page
Loading...
