Figure 26. Advanced Tools window (Path MTU test tool)
3. Click the Run button to the right of the IP address field.
• The Path MTU test result will be shown below the test
controls.
7.6. Advanced settings
7.6.1.
7.6.2. Ethernet settings
The Ethernet settings window contains controls to change the data
exchange speeds of the unit's two RJ45 Ethernet ports.
IMPORTANT
By default, Ethernet speeds are set to Auto. It is strongly
recommended that you do not change the Ethernet speed
settings unless errors and/or unwanted behaviors are detected
on the Ethernet connection.
To change the ethernet speed settings, click the -ethernet settings link
under ADVANCED SETTINGS in the left-hand settings menu.
• The Ethernet Settings dialog will be shown (Figure 27 (page 71)).
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 70 of 132
To Next Page
Loading...
