• Click the -general mode link under GENERAL SETTINGS in the
left-hand settings menu (below).
Figure 17. Configurator GUI (General Mode)
• The GENERAL MODE dialog will be shown (Figure 17
(page 45)).
Changing the operational mode
Operational mode settings on a bridge network-only unit
The Cisco FM Ponte kit kit contains two radio transceiver units. Both units
can only be operated in Bridge Mode.
The Fluidmesh device ID number of the unit that forms the opposite side
of the wireless bridge will be shown in the Configurator window heading
block (Figure 18 (page 45)).
Figure 18. Configurator window heading block
The Bridge ID of the remote unit to which the local unit must be linked is
set at the factory and does not need configuration.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 45 of 132
To Next Page
Loading...
