IMPORTANT
The radio units on both sides of a point-to-point
wireless link must always be set to the same radio
frequency value. A frequency mismatch will result in
communication failure between the units.
9. Click the Next button.
• The configuration confirmation dialog will be shown
(Figure 16 (page 44)).
Figure 16. MeshWizard (confirmation dialog)
10. Confirm that the values entered using the wizard are correct. If
any values need to be changed, click the Back button. If all
values are correct, click the Save and reboot button.
• If you click the Save and reboot button, the configuration
settings will be changed, and the unit will reboot.
7.4. General settings
7.4.1. The General Mode window
The General Mode window contains controls to monitor and/or change the
following settings:
• The unit's LAN parameters.
To change the General Mode settings, do the following steps:
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 44 of 132
To Next Page
Loading...
