Figure 28. Configurator GUI (Static Routes window)
To enter a new static route, do the following steps:
1. Enter the Subnet, Netmask and Gateway designators in the
correct fields of the Add new static route section.
2. Click the add button.
• If the new static route is valid, it will be added to the Active
static routes list.
7.6.4. Multicast
Multicast management for bridge network-capable devices
Multicast is a group-communication method in which data transmissions
are addressed simultaneously to more than one destination computer.
Multicast traffic can only be forwarded through the local Cisco FM Ponte
kit unit to the remote Cisco FM Ponte kit unit, and through the remote unit
to the local unit.
To enable or disable multicast traffic forwarding on a Cisco FM Ponte
kit unit, do the following steps:
1. Click the -multicast link under ADVANCED SETTINGS in the
left-hand settings menu.
• The MULTICAST dialog will be shown (Figure 29 (page
73)).
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 72 of 132
To Next Page
Loading...
