• If an icon is green, the performance of all links is optimal
(green link lines).
• A tooltip is shown below each stationary transceiver icon (below).
• In clockwise order, the tooltip shows the following information:
• The device type icon. Depending on device type, any of three
icons may be seen:
• The icon below will be shown if the device is a
stationary non-Fluidity device:
• The icon below will be shown if the device is a
stationary device that is part of a Fluidity network:
• The icon below will be shown if the device is a mobile
device that is part of a Fluidity network. Note the
dynamic Wi-Fi reception-style symbol. This shows
whether the current RSSI is weak, acceptable or
strong:
• The device label, corresponding to the device’s name
configuration parameter (Alexa in the image above).
• If the device is a mobile radio transceiver, the device’s
Principal/Subordinate setting will be shown. A Principal
device is marked M (for Master), and a Subordinate device is
marked S (for Slave).
• The device’s IP address.
• If the device is a stationary mesh end, it will be marked ME. If
it is a stationary mesh point, it will be marked MP. If it is a
mobile radio, the RSSI (in dBm) between the radio and the
stationary radio to which it is connected will be shown.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 56 of 132
To Next Page
Loading...
