Cisco IP DECT 6800Series - Change the Volume on a Call

To Next Page

To Previous Page

Change the Volume on a Call

Procedure

While on a call, press Volume up or down.

Cisco IP DECT 6800 Series User Guide

Settings

Change the Volume on a Call

Main Page

Default Chapter3
- Table of Contents3
CHAPTER 1 Your Handset11
C H a P T E11
- Feature Support13
- New and Changed Information13
  - New and Changed Information for Firmware Release 4.715
  - New and Changed Information for Firmware Release V46015
- Getting Started16
- Buttons and Hardware18
- Care of Your Handset25
- Additional Help and Information28
CHAPTER 2 Handset Setup31
- Handset Hardware Installation31
  - Handset Package Contents31
  - Install the Battery in the Handset32
    - Remove the Handset Clip35
- Handset Battery Charging37
  - Set up the Charging Cradle37
  - Charge the Handset Battery38
- Automatic Handset Configuration38
- Manual Handset Configuration40
- Handset Firmware Upgrades40
CHAPTER 3 Calls43
- Make Calls43
- Answer a Call47
- End a Call49
- Hold and Resume a Call49
  - Swap between Active and Held Calls49
- Mute Your Call50
- Create a Conference Call50
- Transfer a Call50
- Broadworks Shared Call Appearance51
- Star Codes52
- Use Push to Talk55
- Paging55
Procedure55
Step 255
- Send a Page56
CHAPTER 4 Text Messages57
- Send a Text Message57
- Reply to a Text Message Immediately58
- Add a Text Message Sender to Your Local Contacts59
- Append a Text Message Sender to a Local Contact59
- Forward a Text Message60
- Delete a Text Message Immediately60
- Delete All Text Messages61
- View Your Text Message History61
- Configure Your Text Message Settings63
Text Messages63
- Procedure63
Step 1 Press Menu63
Step 163
Step64
CHAPTER 5 Contacts and Directories65
- Local Contacts65
- Directories68
  - Call a Central Directory Contact68
CHAPTER 6 Recent Calls and Voicemail69
- Recent Calls List69
- Access Your Voicemail70
CHAPTER 7 Alarm Clock, Emergency Alarm List, and Function Keys73
- Alarm Clock73
- Emergency Alarm List75
  - View the Received Emergency Alarms76
- Function Keys76
CHAPTER 8 Settings81
- Settings Menu81
- Set the Ring Volume for an Incoming Call96
- Change the Volume on a Call97
Accessories99
- Supported Headsets99
- Important Headset Safety Information99
- Audio Quality100
Chapter 9 C H a P T E101
Troubleshooting101
- General Troubleshooting101
- View the Handset Status104
- Reset the Handset Settings104
Product Safety and Security105
- Safety and Performance Information105
- System Behavior During Times of Network Congestion108
- Product Label108
- Compliance Statements108
- Cisco Product Security Overview112
- Important Online Information112

Cisco IP DECT 6800Series - Change the Volume on a Call

Table of Contents

Related product manuals