1-4
Cisco IR829 Integrated Services Router Hardware Installation Guide
Chapter 1 Product Overview
General Description
Figure 1-6 Cisco IR829 LED Detail
The following section shows a detailed description of the LEDs.
LEDs
The following table describes the LEDs for the Cisco IR829.
Ta b l e 1-1 LED Descriptions
LED Activity Description
PWR Power Status Off — No power
Green Steady on — Normal operation
Green Flashing — Boot up phase or in ROM Monitor
mode
Yellow Steady on — System shutdown due to under or
over voltage conditions
Yellow Flashing — System has an error, but has network
connectivity
POE POE Power Supply
Status
Off — No -54V PoE power supply detected or no PoE
board installed
Green Steady on — 53.5V POE power supply good and
all powered port operating normally
Yellow Steady on — 53.5V POE power supply good, but
one or more POE ports has a fault.
VPN VPN Off — No VPN tunnel
Steady on — At least one VPN tunnel is up
GE0 WAN Link Status Off — No link
Steady on — Link is up
Blink — Transmitting and Receiving data
To Next Page
Loading...
