8-11
Cisco Wireless ISR and HWIC Access Point Configuration Guide
OL-6415-04
Chapter 8 Configuring VLANs
VLAN Configuration Example
Notice that when you configure a bridge group on the radio interface, these commands are set
automatically:
bridge-group 2 subscriber-loop-control
bridge-group 2 block-unknown-source
no bridge-group 2 source-learning
no bridge-group 2 unicast-flooding
bridge-group 2 spanning-disabled
When you configure a bridge group on the FastEthernet interface, these commands are set automatically:
no bridge-group 2 source-learning
bridge-group 2 spanning-disabled
To Next Page
Loading...
