Cisco MDS 9000 Configuration Guide

CHAPTER
Send documentation comments to mdsfeedback-doc@cisco.com
2-1
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
OL-7765-02
2
Initial Switch Configuration
This chapter provides instructions for setting up the hardware, connecting to the console port, and
initially configuring the switch from the CLI.
This chapter includes the following sections:
• Preparing for Network Connections, page 2-1
• Connecting the Console Port, page 2-2
• Connecting the 10/100 Ethernet Management Port, page 2-4
• Using the Switch Setup Utility, page 2-5
• Verifying the Module Status, page 2-9
Preparing for Network Connections
When preparing your site for network connections to the Cisco MDS 9000 switch, consider the
following:
• Cabling required for each interface type
• Distance limitations for each signal type
• Additional interface equipment needed
Before installing a device, have all additional external equipment and cables available.
Configuration Prerequisites
Before you configure a switch in the Cisco MDS 9000 Family for the first time, make sure you have the
following information:
• Administrator password.
• Switch name—This name is also used as your switch prompt.
• IP address for the switch’s management interface.
• Subnet mask for the switch's management interface.
• IP address of the default gateway.

Cisco MDS 9000 Specifications

General

Brand	Cisco
Model	MDS 9000
Category	Switch
Language	English