Name: Cisco MDS 9000
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Send documentation comments to mdsfeedback-doc@cisco.com

2-7

Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide

OL-7765-02

Chapter 2 Initial Switch Configuration

Using the Switch Setup Utility

Note The switch name is limited to 32 alphanumeric characters. The default is switch.

Enter the switch name: switch_name

Step 10 Enter yes (yes is the default) to configure the out-of-band management configuration.

Continue with Out-of-band (mgmt0) management configuration? (yes/no) [y]: yes

a. Enter the IP address for the mgmt0 interface.

Mgmt0 IP address : mgmt_IP_address

b. Enter the netmask for the mgmt0 interface in the xxx.xxx.xxx.xxx format.

Mgmt0 IP netmask : xxx.xxx.xxx.xxx

Step 11 Enter yes (yes is the default) to configure the default gateway (recommended).

Configure the default-gateway: (yes/no) [y]: yes

Step 12 Enter the default gateway IP address.

IP address of the default-gateway: default_gateway

Step 13 Enter no (no is the default) to configure advanced IP options such as in-band management, static routes,

default network, DNS, and domain name.

Configure Advanced IP options (yes/no)? [n]: no

Step 14 Enter yes (yes is the default) to enable Telnet service.

Enable the telnet service? (yes/no) [y]: yes

Step 15 Enter no (no is the default) to not enable the SSH service.

Enable the ssh service? (yes/no) [n]: no

Step 16 Enter no (no is the default) to not configure the NTP server.

Configure the ntp server? (yes/no) [n]: no

Step 17 Enter noshut (shut is the default) to configure the default switch port interface to the noshut state.

Configure default switchport interface state (shut/noshut) [shut]: noshut

Step 18 Enter on (on is the default) to configure the switch port trunk mode.

Configure default switchport trunk mode (on/off/auto) [on]: on

Step 19 Enter deny (deny is the default) to configure a default zone policy configuration.

Configure default zone policy (permit/deny) [deny]: deny

This step denies traffic flow for all members of the default zone.

Step 20 Enter yes (no is the default) to enable a full zone set distribution (refer to the Cisco MDS 9000 Family

Configuration Guide).

Enable full zoneset distribution (yes/no) [n]: yes

You see the new configuration. Review and edit the configuration that you have just entered.

Cisco MDS 9000 Configuration Guide

Other manuals for Cisco MDS 9000