Cisco Meraki MR36H - Verification and Troubleshooting; Verify Device Functionality

31/01/2022, 19:00
MR36H Installation Guide - Cisco Meraki
https://documentation.meraki.com/MR/MR_Installation_Guides/MR36H_Installation_Guide
16/21
Verify Device Functionality and Test Network Coverage
1. Check LEDs
1. The Power LED should be solid green (or blue, if clients are connected). If it is flashing blue, the firmware
is upgrading and the LED should turn green when the upgrade is completed (normally within a few
minutes). See the "LED Indicators" section for more details. .
2. Note: Your MR36H must have an active route to the Internet to check and upgrade its firmware.

How can we help you?
