Cisco Meraki MR36H - Configuration and Initial Setup; Power and Reset Options; LED Indicators

31/01/2022, 19:00
MR36H Installation Guide - Cisco Meraki
https://documentation.meraki.com/MR/MR_Installation_Guides/MR36H_Installation_Guide
6/21
Power Source Options
The MR36H access point can be powered via PoE using either the Meraki PoE Injector (sold separately), or a
PoE switch.
The MR36H will function in low power mode when powered by a 802.3af power source. While in low power
mode, the MR36H will disable 802.3af out on the LAN1 port. Despite being in low power mode, the device can
still supply full wireless capabilities.
Factory Reset Button
If the button is pressed and held for at least five seconds and then released, the MR36H will reboot and be
restored to its original factory settings by deleting all conguration information stored on the unit.
The factory reset button is located on the rear of the unit and must be ejected from the mount plate in order to
be activated.
LED Indicators

How can we help you?
