Need help?Do you have a question about the Cisco MR74 and is the answer not in the manual?
General| Model | MR74 |
|---|---|
| Product Type | Wireless Access Point |
| Beamforming Technology | Yes |
| Frequency Bands | 2.4 GHz, 5 GHz |
| Antenna Gain | 5 dBi |
| Ethernet Ports | 1 x Gigabit Ethernet |
| Power over Ethernet (PoE) | 802.3at |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Mounting Options | Wall, Ceiling |
| Security | 802.1X |
| Management Features | Cisco DNA Center |
| Operating Humidity | 10% to 90% (non-condensing) |
| Total Number of Antennas | 2 internal antennas per radio (4 total) |
Lists the items included in the MR74 access point package.
Describes the radios and external antenna connectors on the MR74.
Explains how the MR74 can be powered via PoE switch or injector.
Details the function of the MR74's LED and the "Run Dark" mode.
Guides on adding the MR74 to the Meraki Dashboard network before installation.
Recommends firmware upgrade before mounting the MR74 for optimal performance.
Explains firewall requirements for MR74 to communicate with the Cloud Controller.
Details methods for assigning IP addresses to MR74 access points.
Lists the necessary tools for performing an MR74 installation.
Lists the additional hardware needed for installing the MR74.
Provides guidance on selecting an optimal mounting location for the MR74.
Covers the physical installation steps for mounting the MR74.
Verifies the MR74's functionality and tests network coverage after installation.
States that installation requires qualified personnel with RF knowledge.
Outlines requirements for installation and operation of outdoor WLAN systems.
Specifies installation location requirements for RF exposure compliance.
Emphasizes using only approved antennas to avoid FCC violations.
Warns to select installation position carefully to avoid exceeding output power limits.
To Next Page