Cisco Nexus 1000V - Page 273

27-3
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
OL-31593-01
Chapter 27 Cisco TrustSec
Cisco TrustSec Troubleshooting Commands
Example
Example 27-1 vemcmd show learnt ip Command
switch# vemcmd show learnt ip
IP Address LTL VLAN BD
/SegID
10.78.1.76 49 353 7
switch#
Example 27-2 vemcmd show cts global Command
switch# vemcmd show cts global
CTS Global Configuration:
CTS is: Enabled
CTS Device Tracking is: Enabled
switch#
Example 27-3 vemcmd show cts ipsgt Command
switch# vemcmd show cts ipsgt
IP Address LTL VLAN BD SGT Learnt
10.78.1.76 49 353 7 6766 Device Tracking
switch#
vemlog debug sfdhcps_binding_table all Enables the data path debug logging and captures
logs corresponding to the binding database
changes. To view the logs, enable DHCP snooping
on the Cisco Nexus 1000V.
vemlog debug sfipdb all Enables the data path debug logging and captures
logs corresponding to the IP database that
maintains the IP addresses for all the virtual
machines that are being tracked using Cisco
TrustSec device tracking. To view the logs, enable
Cisco TrustSec device tracking on the Cisco
Nexus 1000V.
vemcmd show learnt ip Displays the Cisco TrustSec configuration on the
Cisco Nexus 1000V. See Example 27-1 on
page 27-3
vemcmd show cts global Displays if Cisco TrustSec is enabled on the Cisco
Nexus 1000V. See Example 27-2 on page 27-3
vemcmd show cts ipsgt Displays the Cisco TrustSec configuration on the
Cisco Nexus 1000V. See Example 27-3 on
page 27-3
ESX Host Command Description