Cisco Nexus 3600 NX-OS - Applying an IP ACL as a Port ACL; Applying an IP ACL as a Router ACL

PurposeCommand or Action
(Optional)
Copies the running configuration to the startup
configuration.
copy running-config startup-config
Example:
switch(config-if)# copy running-config
startup-config
Step 4
Related Topics
•
Creating an IP ACL
Applying an IP ACL as a Port ACL
You can apply an IPv4 ACL to a physical Ethernet interface or a PortChannel. ACLs applied to these interface
types are considered port ACLs.
Some configuration parameters when applied to an PortChannel are not reflected on the configuration of
the member ports.
Note
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enters interface configuration mode for the
specified interface.
switch(config)# interface {ethernet
[chassis/]slot/port | port-channel
channel-number}
Step 2
(Optional)
Displays the ACL configuration.
switch# show running-config
Step 3
(Optional)
Copies the running configuration to the startup
configuration.
switch# copy running-config startup-config
Step 4
Applying an IP ACL as a Router ACL
You can apply an IPv4 or or IPv6 ACL to any of the following types of interfaces:
•
Physical Layer 3 interfaces and subinterfaces
•
Layer 3 Ethernet port-channel interfaces and subinterfaces
•
Management interfaces
Cisco Nexus 3600 NX-OS Security Configuration Guide, Release 7.x
87
Configuring IP ACLs
Applying an IP ACL as a Port ACL